Sterling Power Products Pearl - Manual (Page 10)

7 Iss 2
PERSONAL & OPERATIONAL GUIDELINES
The rear body panel, (where fitted), is designed to cover the Drive
Assembly, Main Controller, Wiring Harness and Electrical Connectors.
Only remove this panel for the following:
1. To connect/disconnect cable plugs.
2. To disassemble the scooter for transport.
3. To remove/install batteries.
4. To adjust the seat height.
DO NOT stand on any of the body panels, only the footboard.
DO NOT stand on the scooter seat.
DO NOT attempt to transfer into or out of the scooter seat without first
checking that it is LOCKED into position. Attempting unsafe transfers can
result in bodily injury and/or damage.
DO NOT drive your scooter if the seat is not LOCKED in the FORWARD
position. The seat must be secured in the FORWARD facing position
BEFORE and DURING operation of the scooter. Attempting to operate the
scooter with the seat not secured in the front facing position, could result
in damage and/or bodily injury.
DO NOT operate the scooter without ensuring that the Tiller is properly
adjusted and secured. After making any adjustment to the Tiller position
you must check that the Tiller is locked and secured into position
BEFORE driving. To check, gently push and pull the Tiller to make sure it
is secured.
An unsecured Tiller could result in damage and/or bodily injury.
DO NOT attempt to climb, ascend, or descend ramps greater than
9 degrees, or transverse slopes with a gradient greater than 9 degrees.
When negotiating ramps or inclines, if the throttle lever is released a roll
back will occur.
In FORWARD motion the scooter will ROLLBACK approximately 30cms.
(1ft), before the brake engages.
In REVERSE motion the scooter will ROLLBACK approximately 90cms.
(3ft), before the brake engages.
GENERAL WARNINGS