Sharper Image IB-ECB130 - Manual (Page 3)

Clock Radio Time & Weather Butler Features:
• Indoor & Outdoor Temperature Display
• Male voice announces time reporting and alarm mode
• Easy-to-read display with illuminated LCD/3-level white backlight (HI/MED/LO)
• AM/FM Digital Radio tuning with 8 preset memory
• Dual Alarm Clock – 3 Wake Modes: Radio, Beep Tone or Male voice (report
looping)
• Convenient Snooze/Nap function
• Digital Volume: 1-8 level
• Speaker: 3” diameter
• Operation temperature: +32° F to +122° F (0° C to + 50° C)
• Indoor temperature range: +32° F to +122° F (0° C to + 50° C)
• Operating frequency: 434 MHz
• Maximum Transmission distance: 100 feet (30 meters)
• Power adaptor: 120 Vac input 6 Vdc 300 mA output
• Back-up battery: CR2032 (included)
5 4
Fig. 1
EC-B130_Clock Radio Weather ButlPage 1 7/6/09 4:50:10 PM
Outdoor Temperature Remote Sensor Specifications:
• Outdoor temperature range: -4° F to +140° F (-20° C to +60° C)
• Operating frequency: 434MHz
• Maximum Transmission distance: 100 feet (30 meters)
• Battery power: 2xAAA (not included))
Initial Setup
Alarm Clock Battery Installation:
1. Remove battery compartment cover on the bottom of the unit. Insert one
included CR2032 battery into the unit according to the polarity direction
indicated. Replace cover and snap into place.
2. Attach the DC end of the adaptor into the DC jack on the base of the unit and
insert the AC plug into a 120 VAC outlet.
NOTE: In the event of a power outage the battery is designed to provide memory
back-up for the clock radio settings and alarm settings. The time will not be
illuminated on the clock display when there is no AC power available. As soon as
the power supply returns, the display will indicate the correct time.
NOTE: To hold the time, radio settings and alarm time the back-up battery must
be installed.
Outdoor Remote Sensor Battery Installation:
1. Loosen the 4 screws securing the battery cover with a small screwdriver
(included) and remove.
2. Insert 2xAAA alkaline batteries according to the polarity direction indicated.
3. Place the home receiver (Clock Radio Time & Weather Butler) as close as
possible to the remote sensor. This will help with synchronization between the
two units.
4. The remote sensor is preset to °F. Press the ˚C/˚F button inside the remote
sensor to change between °C and °F.
5. Press the TX button inside of the remote sensor to verify the reception.
6. Replace the cover and tighten the 4 screws.
NOTE: It is recommended to first test the units next to each other to ensure that
both the remote sensor and home receiver are properly synchronized.