Snapper 1733866 - Manual (Page 8)

6
Component Installation
Figure 6. Lower Chute to Boot Installation
A. Pin, Latch
B. Carriage Bolt, 1/4-20 x 5/8
C. Locknut, 1/4-20
D. Lower Chute
E. Locknut, Center Lock, 5/16-18
F. Strap, Rubber
G. Locknuts, Whiz Lock, 5/16-18
H. Rod, Boot Mount
I.
Capscrew, Hex Head, 5/16-18 x 1-1/4
J. Capscrew, Hex Head, Thin, 5/16-18 x 1
D
B
C
F
A
G
G
H
I J
E
LOWER CHUTE ROD AND PIN INSTALLATION
1. Insert the head of pin (A, Figure 6) through front hole
of lower chute (D). Secure with 1/4-20 x 5/8 carriage
bolt (B) and 1/4-20 lock nut (C) as shown.
2. Install the rod (H) to lower chute (D) using 5/16-18 x
1 capscrew (J) and 5/16-18 locknut (G) for front
holes. Use 5/16-18 x 1-1/4 capscrew (I) and 5/16-18
locknut (G) as shown. Tighten hardware.
3. Install the rubber strap (F) onto capscrew (I) securing
with 5/16-18 locknut as shown.
Figure 7. Handle to Tube Installation
A. Handle
B. Locknuts, KEPS, 1/4-20
C. Screw, Slotted, 1/4-20 x 1/2
D. Screw, Slotted, 1/4-20 x 1
E. Strap, Rubber
F. Locknut, Center Lock, 1/4-20
HANDLE INSTALLATION
1. Install handle (A, Figure 7) using 1/4-20 x 1/2 screw
and 1/4-20 locknut (B) for rear hole. Use 1/4-20 x 1
screw (D) as shown. Tighten hardware.
2. Install strap (E) to screw (D) securing with 1/4-20
locknut (F).
B
D
B
F
A
E
C
Component Installation
INSTALL MOUNTING PLATE
1. Install mounting plate (A, Figure 5) to mower deck as
shown. Secure with 5/16-18 x 5/8 carriage bolts (C)
and 5/16-18 locknuts (A).
Figure 5. Install Mounting Plate
A. Mounting Plate
B. Locknuts, 5/16-18
C. Carriage Bolts, 5/16-18 x 5/8
C
B
A