Simplicity Manufacturing I7524E - Manual (Page 4)

Intermediate Frame Snowthrowers
TP 300-5196-00-IS-SN 6/2006 4
Uncrating
1. Using a reciprocating saw, cut crate sides from bot-
tom skid. Lift crate from bottom skid.
2. Remove screws securing skid shoes to bottom skid.
Roll snowthrower from bottom skid backwards.
3. Make sure klik-pin is inserted through hole in wheel
and axle shaft and secured.
Assembly
Install Drift Cutters
Drift cutters (if equipped) are mounted to snowthrower
auger housing backwards or shipped loose. Refer to
Figure 3. Remove hardware and install drift cutters with
hardware as shown.
Figure 1. Klik-pin-locked
A. Klik-Pin
Figure 3. Assemble Drift Cutters
A. Taptite Screw,
E Round Hole
5/16-18 x 3/4 F. Nut, 5/16-18
B. Drift Cutter G. Lockwasher, 5/16-18
C. Tab H. Capscrew,
D. Square Hole 5/16-18 x 3/4
A
The tires are over inflated for shipping purposes. It is very
important to reduce the tire pressure to the following
pressure:
Reduce and
Check Tire Pressure
Figure 2. Checking Tire Pressure
B
F
H
G
Size PSI bar
15 x 5.0-6 20 1,38
4.80-8 20 1,38