Simplicity Manufacturing I7524E - Manual (Page 8)

Intermediate Frame Snowthrowers
TP 300-5196-00-IS-SN 6/2006 8
Figure 16. Lubricating the Auger Shaft Assembly
A. Grease Fittings
C. Cotter Pins
B. Shear Pins D. Auger Assembly
A
B
D
C
A
B
D
C
LUBRICATING THE AUGER SHAFT &
ASSEMBLY
1. Remove cotter pin (C, Figure 16) and shear pin (B).
2. Use a grease gun and squirt several shots of grease
into grease fitting (A).
3. Rotate auger assembly (D) several times to distribute
the grease evenly. Repeat step 2.
4. Reinstall shear pin (B) and cotter pin (C).
5. Repeat procedure for other side.
Figure 12. Lubricate Points Where chute Contacts
Flange (Oil); Lubricate Ring Gear and Pinion Gear
While Rotating Spout (Grease)
Figure 13. Lubricate Points Where Control Rods
Pass Thru Bracket
Figure 14. Lubricate Free Hand Control
Figure 15. Drive Lubrication
A. Hex Shaft
A