Sharp CDPC3500 - Manual (Page 21)

<P=002>
(Continued)
■
Sleep operation
The radio, compact disc and cassette deck can all be turned off
automatically.
1
Play back the desired sound source.
2
Press the TIMER/SLEEP button repeatedly until "SLEEP" is
displayed.
To change the sleep time:
While the sleep time is displayed, press the TUNING/TIME ( X
or W ) button to adjust the time.
(Maximum: 3 hours - Minimum: 1 minute)
The amount of sleep time can also be changed during the sleep
operation.
● 3 hours - 5 minutes → 5-minute intervals
● 5 minutes - 1 minute → 1-minute intervals
3
Press the MEMORY/SET button.
4
The unit will turn off automatically after the preset sleep time
has elapsed.
Note:
● Once the sleep time is set, it will remain the same duration
until the setting is changed.
To confirm the remaining sleep time:
Press the TIMER/SLEEP button.
To cancel the sleep operation:
Press the ON/STAND-BY button to enter the stand-by mode.
USING EXTERNAL UNITS
■ Video/Auxiliary (Audio signal) input
To listen to or record signals from external sources
through this unit:
1
Use an RCA cord to connect the desired external unit to the
VIDEO/AUX 1 or 2 jacks.
(red
➞ right channel, white ➞ left channel)
● When using video equipment (video disc player or VCR), be
sure to connect the audio output to this unit and the video
output to a television.
2
Press the ON/STAND-BY button to turn the power on.
3
Press the VIDEO/AUX button.
● Select either "VIDEO 1" or "VIDEO 2".
4
Operate the external unit.
5
To record the sound from the external unit, perform steps 2
- 4 of the "Recording from the built-in radio" section on page
18.
Note:
● To prevent hum interference, do not place this unit near a
television receiver.
■
CD digital output (optical)
The CD digital signal from this unit can be recorded by
other DAT or MiniDisc recorders.
1
Remove the CD DIGITAL OUT jack cover.
2
Use a commercially available digital cable to connect the unit
to the OPTICAL IN jack of a MiniDisc recorder or a DAT.
3
Put the external unit in the recording mode.
4
Play a CD on this unit.
Note:
● Only CD signals can be output.
TIMER/
SLEEP
MEMORY/
SET
TUNING/
TIME
( )
2
3
(Main unit operation)
To the line output jack
RCA
cord
Commercially available digital cable
CD-PC3500(SEC) TINSE0281AWZZ
20