Pendant type installation – Samsung SPD-3700T User Manual

Page 7

Advertising
background image

12

SPEED DOME CAMERA ACCESSORIES

13

SPEED DOME CAMERA ACCESSORIES

Video Output

Communications

and AUX

Refer to the below Control

Signal Connection diagram

Power Supply

AC24V 2.5A

Alarm

Alarm Output

Alarm Input

Fan Heater

Connector

Power Input

AUX Output

Ground

· RS485 Communications

· RS422 Communications

Camera

Camera

D+

D-

D+

D-

TX+

TX-

TXD+

TXD-

TXD+

TXD-
RXD+

RXD-

Controller

or DVR

Controller

or DVR

Safety

Cable

Alignment

Direction

Guides

Alignment

Direction

Guides

STH-380PO/370PO/370PI/360PO

STH-380PO/370PO/370PI/360PO

Camera Wiring Diagram

•Themaximumcapacityofthealarmand

AUXoutputterminalsisDC30V2A.

•ConnectingthepowerconnectorandGND

incorrectlytotheNC/NOandCOMports
can cause a short circuit which may lead
to fire and damage the camera.

Notes

Control Signal Connection

7. Preparing Camera

Once the camera wiring is successful, prepare the

camera. Every housing-typed camera except the

flush model is provided with a dome cover first

detach the dome cover from the camera.

8. Setting Up Camera DIP Switches

DIP switches for communication and ID protocols are located on the bottom of the

camera. For the switch settings, refer to the appendix of this manual.

9. Connecting Camera Safety Cable and Attaching Camera
Carefully attach the camera to the mount following the alignment guide marks as shown in

the picture. First hook the camera's safety cable on the mount, and then attach the camera.

The safety cable is coiled inside the install base. As shown in the leftward picture, pull out

the safety cable from the install base and then hook it to the mount.

Alignment

Directions

Pendant Type Installation

Pendant Type Installation

Protocol(SW2)

ID(SW1)

To attach the camera to the mount, refer to the alignment guide marks as shown in the picture.

•Makesuretofirsthookthecamera'ssafetycabletothemountbeforeproceeding.Otherwise

youmaybeexposedtoseriousinjurycausedbyafallencamera.

Notes

This wiring diagram indicates the connection between the interface board and external

equipment. For wiring Samsung Techwin’s Speed Dome Camera and the accessories,

please refer to the Speed Dome Camera user’s manual.

Advertising