Assembly – Woodstock SHOP FOX W1772 User Manual

Page 17

Advertising
background image

-15-

W1772/W1773 37" Drum Sander

SE

T

U

P

Assembly

To attach the top cover, control panel, and handwheel

to the drum sander, do these steps:

1. Remove the six button head cap screws from the top

cover shown in

Figure 7, and remove the two lock

knobs shown in

Figure 8.

2. Place the top cover on the sander and attach the

hinges with the screws removed in

Step 1.

Note: To close the top cover fully, tuck the gas struts

under the cover.

3. While an assistant holds the top cover up, install each

strut on a bracket with a jam nut, as shown in

Figure

9. The threaded end of each strut should be flush with

the outside of the bracket.

4. Close the top cover, remove the cap screws securing

the pulley cover, and open the cover.

5. Pull the V-belt down to rotate the sanding drums,

and listen for any scraping sounds.

— If the sanding drums scrape the plastic dust scoop

or metal dust scoop plates on the top cover, refer

to instructions on

Page 43 for adjusting the dust

scoops.

— If you do not hear any scraping sounds go to

Step

6.

6. Reinstall the pulley cover with the cap screws removed

in

Step 4, and reinstall the knobs removed in Step 1,

to secure the top cover.

Figure 7. Removing cap screws on top

cover.

Figure 8. Lock knobs and hinges.

Hinges

Figure 9. Gas strut installed (right side

shown).

Bracket

Jam Nut

Gas Strut

Lock Knobs

Advertising
This manual is related to the following products: