Woodstock SHOP FOX W1772 - Manual (Page 32)

-30-
W1772/W1773 37" Drum Sander
M
A
IN
TE
N
A
N
CE
MAINTENANCE
Regular periodic maintenance on your Model W1772/
W1773 will ensure its optimum performance. Make a
habit of inspecting your machine each time you use it.
Check for the following conditions and repair or
replace when necessary:
• Loose mounting bolts.
• Worn switch.
• Worn or damaged cords and plugs.
• Worn or damaged sandpaper.
• Damaged V-belts.
• Any other condition that could hamper the safe
operation of this machine.
General
MAKE SURE that your machine is
unplugged during all maintenance
procedures! If this warning is ignored,
serious personal injury may occur.
OFF
Cleaning the Model W1772/W1773 is relatively easy. From
time to time, vacuum wood dust off of the internal compo-
nents, especially the motor.
Cleaning
Lubrication
Moving parts, such as chains, should be lubricated peri-
odically with a light machine oil. Motor bearings need no
lubrication.
Pillow Bearing: Must be lubricated every 20 hours of
operation. Use a high-quality, lithium-based grease. A
grease fitting ( Figure 32) is located on the top of each
pillow bearing. Give only one to two pumps of the grease
gun. Too much grease can pop seals out.
Gearbox: Change the oil in the gearbox every 500 hours
with new 80-90W automotive grade gear oil.
1. Remove the variable speed knob, the hex nut,
knurled collar, and the four button head screws
securing the feed motor cover (see Figure 33).
Figure 32. Location to lubricate pillow
bearing.
Grease
Fitting
Figure 33. Removing feed motor cover.
Collar
Hex Nut
Speed
Knob
Bar