Playing the ipod – Sony Muteki LBT-ZX99I User Manual

Page 20

Advertising
background image

20

US

To set CD power on

Repeat the procedure above and “CD
POWER ON” appears in the display.

Notes

• When “CD POWER OFF” is selected, disc

access time is increased.

• You cannot change the CD power manage

setting in Power Saving Mode (page 27).

To change the AM tuning interval

The factory setting for AM tuning interval
is 10 kHz.
Use the buttons on the unit for the
operation.

1

Press TUNER/BAND repeatedly to
select AM band.

2

Press "/1 to turn off the system.

3

When demonstration appears, hold
down TUNING MODE and then
press "/1.
The system turn on automatically.
“AM 9K STEP” or “AM 10K STEP”
appears in the display.

When you change the interval, all the AM
preset stations are erased.

Tip

To improve broadcast reception, adjust the
supplied antennas, or connect an external
antenna.

To reduce static noise on a weak FM
stereo station

Press FM MODE repeatedly until
“MONO” lights up in the display.
There will be no stereo effect, but the
reception will improve.

Playing the iPod

You can listen to audio contents stored in
the iPod on this system.

1

Press iPod.

2

Place the iPod.

3

Press NX (or N on the
remote) to start playback.

4

Turn VOLUME +/– (or press
VOLUME +/– on the remote) to
adjust the volume.

Notes

• When you connect an iPod to the unit, the

iPod is automatically turned on if the system

is turned on.

• When placing or removing the iPod, handle

the iPod in the same angle as that of the iPod

connector on the unit and do not twist or sway

the iPod to prevent connector damage.

• Do not carry the unit with an iPod set on the

connector. Doing so may cause a malfunction.

• When placing or removing the iPod, brace the

unit with one hand and take care not to press

the controls of the iPod by mistake.

• Before disconnecting the iPod, pause

playback.

• Depending on the connected iPod, you may

not able to use m or M while playing

video. In this case, you can fast rewind or fast

forward by holding down . or >.

• To change the volume level, use

VOLUME +/–. The volume level does not

change even if adjusted on the iPod.

• This iPod connector is designed for iPod only.

You cannot connect any other portable audio

players.

Advertising
This manual is related to the following products: