Sony XAVW1 - Manual (Page 18)

RCD-W1 (US) 4-233-692-12(1) Actual page number:
18
5
Adjust the recording level (ANALOG IN
only), if necessary. For details, see
“Adjusting the Recording Level” on
page 19.
6
Press H .
7
Start playing the sound source you
want to record.
To pause recording
Press X. To resume recording, press the button
again or press H.
Note
Whenever you pause recording, a new track number
is added. For example, if you paused recording while
recording on track 4, the track number increases by
one and recording continues on the new track when
recording is resumed.
To stop recording
Press x.
“BUSY”, and then “UPDATE” appear while
updating the information of the disc before
stopping the recording.
Notes
• You cannot record over the existing material when
“PGM” or “SHUF” appears in the display.
• You cannot operate the CD player section while the
deck is recording or standing by for recording with
“OPT” or “ANLG” selected with the INPUT
button.
• If you press the REC button during recording, you
can add a track (The track must be longer than 6
seconds).
• Press X when the recorder is in standby for
recording to add a silent (around 2 seconds) before
a song you are recording. The recorder
automatically enters standby again.
• This recorder uses the Serial Copy Management
System, which allows only first-generation digital
copies to be made of premastered software via the
recorder's digital input. Therefore you may not be
able to record a CD-R or CD-RW digitally through
OPTICAL IN, depending on the content being
record.
• For recording from ANALOG IN with no track data,
the track number will be increased when the
recorder receives silence for 3 seconds. The
recorder will also go into the pause mode until the
input source resumes.
• When track data is present from a digital recording,
it will be carried over to the new recordable disc.
Thus when the CD being played moves from one
track to the next track, the recordable disc will also
includes the track number by one.
z
REC z
Select
OPT
ANLG
Recording on a CD-R or
CD-RW disc Manually
You can start recording from the end of the
existing material.
When using the remote, set SELECT to CDR
for operations on DECK B.
To perform Synchro-Recording, see
“Recording a CD to CD-R or CD-RW disc” on
page 15 or “Recording a CD to CD-R or CD-
RW disc at High Speed” on page 16.
1
Turn on the amplifier and set the
source selector to the position for the
sound source you want to record.
2
Place a recordable CD-R or CD-RW on
DECK B.
3
Press INPUT repeatedly to select the
input connector.
To record through
DIGITAL OPTICAL
ANALOG IN
4
Press REC z .
The recorder stands by for recording.
06REC_RCD-W1.p65 00.12.13, 10:33 AM 18