Sony XAVW1 - Manual (Page 23)

Recording on CDR
RCD-W1 (US) 4-233-692-12(1) Actual page number:
23
Erasing an Entire CD-RW
disc
Erasing the entire contents of a CD-RW disc is
easy, and it does not matter whether the disc has
been unfinalized or not.
When using the remote, set SELECT to CDR
for operations on DECK B.
1
Press ERASE one time (for a finalized
disc) or twice (for unfinalized disc) until
“DISC ERASE” appears in the front
panel display.
The “DISC ERASE” indicator will begin to
flash, and the PLAY, PAUSE, and REC
indicators light up for about 8 seconds.
Entire disc erasing enters in the standby
mode.
2
Press PLAY while “DISC ERASE” is
flashing.
Entire disc erasing starts. During erasing,
“DISC ERASE” appears in the front panel
display and the remaining time for entire
disc erasing appears in the display. When
this process is finished, “0 0:00” appears in
the display.
Notes
• The TOC (red) indicator appears on the front panel
display if the disc you put in the DECK B has not
been finalized. Check the indicator each time before
erasing the last track of a disc.
• Once entire disc erasing process starts, you cannot
stop the erasing in the middle of the process.
• Do not turn off the recorder or disconnect the
recorder from the power source in the middle of the
erasing process.
ERASE
ERASE
06REC_RCD-W1.p65 00.12.13, 10:33 AM 23