Sima Products XL-8 - Manual (Page 13)

Page 13
Light Guard Installation with Velcro Strips
Please use the following steps to attach the light guard successfully using the Velcro strips.
1. Attach the Velcro strips to
all the grommets on the
frame rear of the as shown
in figure 28.
2. Unroll the black vinyl light
guard from the accessory
box in the package.
3. Begin to lace each Velcro
strip to secure the light
guard to the frame by
looping the Velcro through
the back of the grommet in
the screen, and passing
the Velcro strip through t
hole in the top of the strip.
he
h
4. Leave a couple of inches
of slack as you attach eac
Velcro strip the first time
around. This will allow you
to more easily adjust the
screen later once fully
attached.
5. Once the light guard is
attached to the frame,
tighten the Velcro strips.
6. Use the Velcro attachment
pads located on the bottom
of the light guard and the
frame to secure the light
guard for front-projection.
Fig. 28
Fig. 29