Sundance Spas 880 - Manual (Page 46)

Page 40
880 SERIES
When a programmed filter/heating cycle activates, the LCD screen
displays the following message:
At any time, you may check the programming of any economy mode
filter/heating cycle by first pressing (CYCLE)
button then moving
through the menu by pressing either (CYCLE) or (SELECT)
button. The programming is changed only by pressing (UP) or
(DOWN) buttons during this process.
12.3 Adjusting Time of Day
The Sentry control system remembers the time of day even in the event
of a prolonged power outage. However, it may occasionally be necessary
to reset the time of day. For example: if you are not in the Pacific Time
Zone you will want to reset the time for your own time zone. (The
system will automatically adjust to and from daylight savings time.) To
accomplish this, press (DISPLAY)
, (MODE) , and (DISPLAY)
button within five seconds each. A number representing the
hour will be displayed, followed by AM or PM. The hour will advance or
decrease each time the (UP)
or (DOWN) button is pressed
within five seconds. Then, press the (DISPLAY) button again
to display minutes. Adjust minutes as necessary by pressing the (UP)
or (DOWN) button. After 5 seconds, the display will return to
normal and save your settings.
12.4 Main Control Panel Lock
To help prevent unauthorized use of your hot tub, the Sentry controls
incorporate a unique panel locking system which disables the controls on
the panel.
• To Lock The Main Control Panel: Press (DISPLAY) ,
(MODE) , and (UP) buttons within five seconds
each. A padlock symbol will appear on the LCD screen.
With the panel locked, all components are disabled from manual
activation and the only settings that can be adjusted are the standard
and economy filter/heating modes and time of day. All automatic hot
tub functions will operate normally.
• To Unlock Main Control Panel: Press (DISPLAY) ,
(MODE) , and (DOWN) buttons within five
seconds. The lock symbol will disappear. All buttons are now
active.
*Note: Number will vary
according to which filter
cycle is being programmed. *Note: Number will vary
according to which filter
cycle is being programmed.
1* 1*
LOCKED LOCKED