0 important safety instructions – Sundance Spas 880 User Manual

Page 8

Advertising
background image

Page 2

880 SERIES

2.0 Important Safety Instructions

READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY
When installing and using this electrical equipment, basic safety
precautions should always be followed, including:

1. WARNING: To reduce the risk of injury, do not permit children to use

this product unless they are closely supervised at all times.

2. WARNING: A grounding wire connector is provided on this unit to

connect a minimum No. 8 AWG (8.4 mm²) solid copper conductor

between this unit and any metal equipment, metal enclosures of

electrical equipment, metal water pipe, or conduit within 5 feet

(1.5m) of the unit.

3. DANGER: Risk of Accidental Drowning. Extreme caution must be

exercised to prevent unauthorized access by children. To avoid

accidents, ensure that children cannot use this hot tub unless they

are supervised at all times.

4. WARNING: Risk of Injury. The suction fittings in this spa are sized to

match the specific water flow created by the pump. If it is necessary

to replace the suction fittings or the pump, be sure that the flow rates

are compatible. Because of the risk of injury,

Never operate or use the spa if the filter, filter lid, or skimmer

assembly are broken or any part of the skimmer assembly is

missing. Please contact your dealer or nearest service center for

service.

Never replace a suction fitting with one rated less than the flow

rate marked on the original suction fitting.

5. DANGER: Risk of Injury. The suction fittings in this hot tub are

sized to match the specific water flow created by the pump. Should

the need arise to replace the suction fittings or the pump, be sure

that the flow rates are compatible. Never operate the hot tub if the

suction fittings are broken or missing. Never replace a suction fitting

with one rated less than the flow rate marked on the original suction

fitting.

6. DANGER: Risk of Electric Shock. Install at least 5 feet (1.5m), from

all metal surfaces. As an alternative, a hot tub may be installed

within 5 feet of metal surfaces if each metal surface is permanently

connected (bonded) by a minimum No. 8 AWG (8.4 mm²) solid

copper conductor attached to the wire connector on the grounding

lug, inside the equipment compartment on the equipment box.

7. DANGER: Risk of Electric Shock. Do not permit any electrical

appliance, such as a lights, telephones, radios, televisions, etc.

within 5 feet (1.5m) of a hot tub unless such appliances are built-in

by the manufacturer.

Advertising