Sony DVW-250 - Manual (Page 40)

4-1 Preparations for Recording
Time Code Locking of Two or More DVW-
250/250P Units
Connect the DVW-250/250P units as shown in the
figure below.
In this case, on each of the DVW-250/250P units, set
the F-RUN/R-RUN switch to F-RUN and the CONFI
switch to ECC or OFF.
Then set the first DVW-250/250P so that it outputs the
time code generator signal from the TC OUT
connector. For example, when the "TC OUT" item is
set to "AUTO" (see previous page), the unit must be in
the E-E mode.
Example connections for time code locking
4-12 Chapter 4 Recording