Sunrise Medical Quickie M6 - Manual (Page 13)

A. TO MOUNT & REMOVE REAR WHEELS
Do not use this chair UNLESS you are sure both quick-release axles are
locked. An unlocked axle may come off during use and cause a fall.
NOTE– Axle is not locked until:
a. The quick-release button pops out fully. (Fig. 1)
b. The ball bearings are fully visible on the
outside of the sleeve.
1. To Install Wheel (Figs. 1 & 2):
a. Depress quick-release button (1) fully.
This will release tension on ball bearings
at other end.
b. Insert axle through hub of rear wheel.
c. Keep pressure on button (1) as you slide
axle (2) into axle sleeve (3).
d. Release button to lock axle in sleeve.
Adjust axle if it does not lock.
e. Repeat steps on other side.
2. To Remove Wheel:
a. Depress quick-release button (1) fully.
b. Remove wheel by sliding axle (2) out of
axle sleeve (3).
c. Repeat steps on other side.
930457 Rev. A
I X . C h a i r B a s i c s 25
3. Axle Sleeve
2. Axle
Figure 2
V I I I . W a r n i n g s : C o m p o n e n t s & O p t i o n s
930457 Rev. A
24
M. UPHOLSTERY FABRIC
1. Replace worn or torn fabric of seat and seat back as soon as you can. If you fail
to do so, the seat or seat back may fail.
2. Sling fabric will weaken with age and use. Look for fraying, thin spots, or
stretching of fabrics especially at edges and seams.
3. “Dropping down” into your chair will weaken fabric and result in the need to
inspect and replace the seat more often.
4. Be aware that laundering or excess moisture will reduce flame retardation of
the fabric.
If you fail to heed these warnings damage to your chair, a fall, tip-over or loss of control
may occur and cause severe injury to the rider or others.
Figure 1
1. Quick-Release Button