Sunrise Medical Quickie M6 - Manual (Page 17)

930457 Rev. A
X . S e t - U p & A d j u s t m e n t s 33
L. CHECK-OUT
After the wheelchair is assembled and adjusted, it should roll smoothly and easily.
All accessories should also perform smoothly. If you have any problems, follow
these procedures:
1. Review the Set-Up and Check-Out sections and Operating Guide to make
sure chair was properly prepared.
2. Review Troubleshooting Guide.
3. If your problem persists, contact your authorized supplier. If you still
have a problem after contacting your authorized supplier, contact Sunrise
customer service. See the introduction page for details on how to contact
your authorized supplier or Sunrise customer service.
X . S e t - U p & A d j u s t m e n t s
930457 Rev. A
32
K. FOLDING AND UNFOLDING
1. Folding Chair
a. Remove quick-release wheels (optional).
•Depress quick-release button.
•Remove wheel by sliding out quick-release axle from axle bracket.
•Repeat with other wheel.
b. Flip up the footplates to a vertical position before folding the wheelchair.
c. Grasp the seat sling (in the center) and lift sharply until the wheelchair is folded.
d. Unlatch stabilizer bar– Depress thumb button. Swing bar out of the way.
2. Unfolding Chair
a. Replace quick-release wheel (optional) by depressing the quick-release button on
the axle.
b. Slide it into the axle sleeve until it locks.
c. Repeat with other wheel.
d. Tilt the wheelchair toward you far enough to take the weight off the opposite wheel.
e. Push down on the seat rail (closest to you) until the wheelchair is
completely opened.
f. Make sure seat rail tubes are resting in the frame saddles.
g. Reattach stabilizer bar– Swing bar back into place. Depress thumb button to latch.