Sterling Plumbing Harrier 48 - Manual (Page 12)

Remove the mower from the packaging and check that the following
items have been supplied correctly. If any items are missing contact,
your local Hayter dealer.
1. Engine Handbook.
2. Grassbag.
3. Charger (481 Only)
4. Ignition Key (481 Only)
To prevent accidents cut off the long ribbon attached to the grass-
bag and discard.
(481 Only) Note: Prior to first use please fully charge the battery for
14 hours. (Refer to battery charging)
Unscrew the handlebar securing knobs sufficiently to allow the handle-
bar to pivot. Move the engine stop lever away from the engine to avoid
damage and unfold the handlebar to the operating position. Make sure
the knobs are assembled to the outside of the handlebar and tighten to
secure in position.
Take care to ensure that the control cables do not become snagged at
the pivot point.
Unscrew the two larger knobs at base of handlebar sufficiently to
allow it to be moved to the upper, middle or lower position. Ensure
both sides are set to the same height and secure in the required posi-
tion.
Raise the rear deflector, lower the grassbag through the handlebar and
hook in position. Lower the deflector to rest on the grassbag
1.12
ASSEMBLING THE MOWER
Delivery Checklist
Adjust Handlebar Height
Grassbag Attachment
Handlebar
111-0436 (A) 27/10/05 12:57 pm Page 1.12