Sterling Plumbing Harrier 48 - Manual (Page 21)

To prevent accidents stop the engine disconnect the spark plug
lead before attempting to carry out maintenance procedures on
the mower.
1. Air Filter
2. Fuel Cap
3. Start Grip
4. Oil Cap/ Dipstick
5. Exhaust Guard
6. Spark Plug / Lead
Remove two screws securing the engine cowl and remove the cowl
to expose the throttle mechanism on the front of the engine.
Loosen the outer cable clamp screw (1) and move the governor
control lever (2) to the left as far as possible. Insert a large, flat
blade screw driver (3) into the slot in the engine control bracket (4)
at the angle shown. Push the governor control lever to the right
until it just touches the screw driver blade. Move the throttle con-
trol lever to the ‘fast’ position (not the ‘choke’ position) and re-
tighten the outer cable clamp screw. Replace the engine cowl.
Should only be made by an authorised Briggs & Stratton dealer.
Under no circumstances should the engine be adjusted to run at a
speed in excess of that shown on the Declaration of Conformity.
1.21
MOWER
1
2
3
4C481D02A
BRIG GS & S TRA TTON
HAR RIER 41
6 5
4
1
2
3
4
Engine
Throttle Cable Adjustment
Carburettor Adjustments
MAINTENANCE
111-0436 (A) 27/10/05 12:57 pm Page 1.21