Sony DWA-01D - Manual (Page 21)

21 Parts identification
to operate in synchronization, select
“AUTO” or “EXTERNAL” on the SYNC
SOURCE indication of the UTILITY menu
of the DWR-S01D.
Note that this connector does not work
when the WRR-855 is attached.
For details on the frequency of the sync signal, refer
to the Operating Instructions supplied with the
DWR-S01D.
Even when the 75-ohm termination has
been added on the DWR-S01D, this
connector still works as the high-impedance
input connector while the DWR-S01D is
turned off.
c OUTPUT1 (analog audio output)
connector (4-pin)
Outputs balanced analog audio signal.
When the DWR-S01D is attached, audio
from the tuner 1 or 2 can be selected by
using the UTILITY menu of the DWR-
S01D. The output from this connector is
factory-set to the audio from the tuner 1.
When the WRR-855 is attached, audio is
output from this connector only.
d OUTPUT2 (analog/digital audio
output) connector (4-pin)
When the DWR-S01D is attached, this
connector outputs balanced analog audio
signal or AES3-format digital audio signal.
Output signal can be selected using the
ANALOG AES/EBU selector. When this
selector is set to ANALOG, audio from the
tuner 2 is output.
Note that this connector does not work
when the WRR-855 is attached.
e ANALOG AES/EBU selector
When the DWR-S01D is attached, this
selector determines the signal output from
the OUTPUT2 connector.
ANALOG: Balanced analog audio signal is
output.
AES/EBU: AES3-format digital audio
signal is output.
Note that this selector does not work when
the WRR-855 is attached.
Note