Sony DWA-01D - Manual (Page 28)

28 Important notes on operation / Specifications
Important notes
on operation
Notes on using the adapter
• The Digital Wireless Microphone
System product must be used within a
temperature range of 0°C to 50°C (32°F
to 122°F).
• Operating the adapter near electrical
equipment (motors, transformers, or
dimmers) may cause it to be affected by
electromagnetic induction. Keep the
adapter as far from such equipment as
possible.
On cleaning
• If the adapter is used in a very humid or
dusty place or in a place subject to an
active gas, clean its surface as well as the
connectors with a dry, soft cloth soon
after use. Lengthy use of the adapter in
such places or not cleaning it after its use
in such places may shorten its life.
• Clean the surface and the connectors of
the adapter with a dry, soft cloth. Never
use thinner, benzene, alcohol or any other
chemicals, since these may mar the
finish.
Specifications
Audio section
Audio output connector
SMC9-4S (female) (OUTPUT1/
OUTPUT2)
Analog output impedance
150 ohms or less
AES/EBU output impedance
110 ohms
WORD SYNC input
BNC-R, 75 ohms (when the DWR-
S01D is attached to the adapter
and 75-ohm termination is
added)
Monitor output
φ 3.5 mm TRS jack
Monitor output level
50 mW (16-ohm load, at T.H.D =
1%)
General
Power requirements
12 V DC
Operating voltage
10 V DC to 17 V DC
Operating temperature
0°C to +50°C (+32°F to +122°F)
Storage temperature
– 20°C to +60°C ( – 4°F to +140°F)
To prevent electromagnetic
interference from portable
communication devices
The use of portable telephones and other
communication devices near the DWA-
01D may result in malfunction and
interference with audio signals. It is
recommended that portable
communication devices near the DWA-
01D be turned off.