Sony 570WSPL - Manual (Page 88)

88
Chapter 4 Viewfinder Screen Indications and Menus
Chapter 4 Viewfinder Screen Indications and Menus
Time data values appear during playback, fast forward,
rewind, or recording review.
4 NG indication
An “NG” (No Good) indication appears if you
designate a recorded scene as “NG” when using the
ClipLink function for recording.
5 Clip mode indication
A “CLIP M” or “CLIP C” indication appears when
you use the ClipLink function for recording.
CLIP M: Indicates shooting in Mark mode
CLIP C: Indicates shooting in Cue mode
6 Clip remaining indication
The number of available clips is displayed when you
use the ClipLink function for recording.
7 Status display area
One of the following values or messages is displayed
to indicate the camcorder’s current status or its
operation status.
• New values when changing camcorder’s settings
• Messages indicating progress or results of
adjustments
• The camcorder’s current settings
• SetupLog data recorded to a tape during shooting (see
page 115)
8 EZ FOCUS indication
This appears when the EZ FOCUS button is pressed,
enabling the “easy focus” function.
Note
The status indication is not shown while this indication
appears.
9 LOW LIGHT indication
This warning appears if the lighting level is
inadequate.
0 Audio recording level indicators
These show the recording levels of audio channels 1
and 2.
qa Tape remaining indication
This shows the tape remaining as follows.
qs VCR warning indication
This shows warning indications about operation or
status of the VCR.
Viewfinder Normal Indications
DISPLAY switch
setting Time data displayed
COUNTER CNT: Tape transport time
TC TCG: a time code from the time code
generator
TCR: a time code from the time code
reader
U-BIT UBG: a user bit value from the time
code generator
UBR: a user bit value from the time
code reader
Channel 1
Channel 2
– ∞ 0 dB –2 dB
Indication Tape remaining
F-30 At least 30 minutes
30-25 25 - 30 minutes
25-20 20 - 25 minutes
20-15 15 - 20 minutes
15-10 10 - 15 minutes
10-5 5 - 10 minutes
5-0 2 - 5 minutes
5-0 (flashing) 0 - 2 minutes
Indication Meaning
NO TAPE There is no tape loaded.
REC INHIBIT The tape is in the recording inhibited
state.
LOW BATT The battery is almost exhausted.
BATT END The battery is exhausted.
TAPE NEAR END The tape is near the end.
TAPE END The tape is at the end.
SERVO The servo lock has been lost.
HUMID There is condensation.
RF The video heads are clogged, or there
is some other fault in the recording
system.
SLACK The tape is not wound properly.
MP TAPE An incorrect type of cassette has been
loaded. (The cassette is automatically
ejected and the indication disappears
in about two seconds.)
CLIP DATA ERR Abnormality of ClipLink log data in the
cassette memory data.