Sony D-VE45 - Manual (Page 30)

30
Troubleshooting
Should any problem persist after you have checked these symptoms, consult your nearest Sony
dealer.
Symptom
CD playback does not start.
The disc does not play or
“no dISC” appears in the
display when a CD is placed
in the player.
No sound, or noise is heard.
The volume does not increase
even if you press the VOLUME
+ button repeatedly.
Cannot adjust the volume.
Sound seems to lose the
stereo effect and becomes
monaural.
The playing time is too short
when powered with the dry
batteries.
When you press N >,
“Lo
” or “00” appears
in the display. The CD does
not play.
“Lo ” or “HI dc”
appears in the display and
the player does not operate.
Cause and/or corrective actions
c When playing back an audio CD, it takes a while before the sound
is heard.
c The buttons are locked. Slide the HOLD switch back. (page 24)
c The CD is dirty or defective. (page 29)
c Check that the CD is inserted with the label side up. (pages 9, 11)
c Moisture condensation has occurred.
Leave the CD player aside for several hours until the moisture
evaporates.
c The lens is dirty. Clean the lens.
c Close the lid of the player and the battery compartment firmly.
(pages 9, 27)
c Make sure the batteries are inserted correctly. (page 27)
c Connect the AC power adaptor to an AC outlet securely. (pages 8,
11)
c Connect the DC plug of the AC power adaptor to the DC IN 4.5 V
jack on the player securely. (pages 8, 11)
c Batteries are depleted. Replace the batteries with new ones.
c The CD-R was not finalized. Finalize the CD-R with the recording
device.
c There is a problem with the quality of the CD-R, recording device,
or application software.
c Connect the plugs firmly. (pages 8, 11)
c Plugs are dirty. Clean the plugs with a dry soft cloth periodically.
c Hold down SOUND until “AVLS” disappears from the display.
(page 24)
c The earphones are connected to the AUDIO/VIDEO OUT jack.
Connect them to the i jack. (page 11)
c The earphones are connected to the AUDIO/VIDEO OUT jack.
Connect them to the i jack. (page 11)
c Press ST/L/R on the wireless remote control repeatedly until “ST”
appears on the TV screen. (Only when playing a VIDEO CD)
c The audio connecting cord is used to connect the audio device.
Use the supplied /recommended AV cable. (page 26)
c Check that you are using alkaline batteries and not manganese
batteries. (page 27)
c Replace the batteries with new LR6 (size AA) alkaline batteries.
(page 27)
c Replace the batteries with new LR6 (size AA) alkaline batteries.
(page 27)
c Use only the AC power adaptor in “Accessories (supplied/
optional).” (page 33)
c Remove all power sources, then insert the new batteries or connect
the AC power adaptor again. (pages 8, 27)