SPX Cooling Technologies ROBINAIR 17700-2K - Manual (Page 8)

© 2001 Robinair, SPX Corporation
6
240 240 220 220 200 200 180 180
80 80 120 120 100 100 140 140
60 60 20 20 40 40
160 160
3 3 4 4
2 2 1 1
8 8 7 7 6 6 5 5
340 340 320 320
MLS MLS
280 280 300 300 260 260
12 12 11 11 10 10 9 9
OUNCES OUNCES
CLOSED CLOSED
RECOVER RECOVER RECOVER RECOVER
CLOSED CLOSED
CLOSE CLOSE
VACUUM VACUUM VACUUM VACUUM CHARGE CHARGE OIL INJECT OIL INJECT
2 2
0 0
5 5
8
8 MENU MENU
CLEAR CLEAR
7 7
1 1
4 4
START START
RECOVER RECOVER VACUUM VACUUM
F1 F1
ENTER ENTER
9 9
3 3
6 6
STOP STOP
CHARGE CHARGE VAC-CHARGE VAC-CHARGE
FLOW FLOW
LOW LOW HIGH HIGH
Setup Instructions
IMPORTANT!
The pump must
be running
when adding
oil.
IMPORTANT!
For maximum
performance,
change the
vacuum pump
oil frequently.
NOTE: The vacuum pump is shipped without oil in the reservoir. Before starting
the pump, oil must be added to the pump, or damage to the pump may occur.
5. Press the START key to begin the oil fill process.
6. Attach the flexible tube and cap to the oil bottle, and pour eight ounces of
vacuum pump oil into the fill port.
7. Press the START key. While the vacuum pump is running, slowly add oil
until the level rises to the center of the reservoir's sight glass.
8. Press the STOP key, and replace the black plastic plug on the fill port.
9. Connect the service hoses, open both panel valves, and press START .
10. Connect the fill hose to a full source tank.
11. Open the tank valve. Invert the tank and install it on the back of the unit,
making sure to secure the tank strap.
NOTE: If using a refillable tank, install the tank upside down, and connect the fill
hose to the vapor valve.
INST0947
1
2
3
1. Oil Fill
2. Sight Glass
3. Oil Drain
12. Press START, and the unit will automatically run a
five-minute vacuum to clear all internal air.
13. After the vacuum is complete, press START to begin
filling the internal storage vessel.
14. The unit stops when a sufficient amount of refrigerant
has been transferred to the internal tank, or when the
source tank is empty. Press the
STOP key to pause the
process. Press STOP again to exit, or START to
resume. This process takes 15-20 minutes.
NOTE: Add at least 8 lb. (3.6 kg) of refrigerant before
stopping the process to ensure enough refrigerant is available
for charging.
15. When the fill process is complete, you may press STOP
to exit.
16. The unit is now ready to operate.
NOTE: There is no need to calibrate the scale, because it is
calibrated at the factory.