Solo USA MS 270 - Manual (Page 31)

30
English / USA
MS 270, MS 270 C, MS 280, MS 280 C
: Remove the tensioning gear (4)
and turn it over.
: Unscrew the nut (5).
: Position the tensioning gear (4)
against the guide bar (6) so that the
stud (7) projects through the upper
hole and the short guide peg (8)
locates in the lower hole.
: Screw the nut (5) on to the stud as
far as stop.
Wear work gloves to protect your
hands from the sharp cutters.
: Fit the chain – start at the bar nose.
Pay attention to the position of the
tensioning gear and the cutting
edges.
: Turn the tensioning gear (4)
clockwise as far as stop.
4
133BA027 KN
5
133BA028 KN
4
8
7
6
133BA029 KN
5
133BA030 KN
4
133BA031 KN