Solo USA MS 270 - Manual (Page 57)

56
English / USA
MS 270, MS 270 C, MS 280, MS 280 C
: File the top of the depth gauge
parallel to the stamped service
marking (see arrow) – but do not
lower the highest point of the depth
gauge in this process.
The kickback tendency of the
chainsaw is increased if the depth
gauges are too low. : Place filing gauge on the chain –
highest point of depth gauge must
be level with the filing gauge.
PM 1, RM2:
Rear hump of tie strap (with service
marking) is lowered along with the depth
gauge.
RSC3, RMC3, PMC3:
The upper part of the humped drive link
(with service marking) is lowered along
with the depth gauge.
The other parts of the triple-humped
tie strap and humped drive link must
not be filed since this may increase
the kickback tendency of the
chainsaw.
: After sharpening, clean the chain
thoroughly, remove filings or
grinding dust – lubricate the chain
thoroughly.
: Before long out-of-service period,
clean the chain and store it in a
well-oiled condition.
689BA044 KN 689BA052 KN
Sharpening Tools (special accessories)
Chain pitch
Round file Ø Round file File holder Filing gauge Flat file 1) Sharpening kit 2)
inch (mm) mm (inch) Part No. Part No. Part No. Part No. Part No.
1 /
4
(6.35) 4.0 ( 5 /
32
) 5605 772 4006 5605 750 4327 1110 893 4000 0814 252 3356 5605 007 1027
3 /
8
PMN (9.32) 4.0 ( 5 /
32
) 5605 772 4006 5605 750 4327 0000 893 4000 0814 252 3356 5605 007 1026
3 /
8
P (9.32) 4.0 ( 5 /
32
) 5605 772 4006 5605 750 4327 1110 893 4000 0814 252 3356 5605 007 1027
0.325 (8.25) 4.8 ( 3 /
16
) 5605 772 4806 5605 750 4328 1110 893 4000 0814 252 3356 5605 007 1028
3 /
8
(9.32) 5.2 ( 13 /
64
) 5605 772 5206 5605 750 4329 1110 893 4000 0814 252 3356 5605 007 1029
0.404 (10.26) 5.5 ( 7 /
32
) 5605 772 5506 5605 750 4330 1106 893 4000 0814 252 3356 5605 007 1030
1) Use triangular file 0811 421 8971 for PM1 and RM2
2) consisting of file holder with round file, flat file and filing gauge