Solo USA MS 270 - Manual (Page 63)

62
English / USA
MS 270, MS 270 C, MS 280, MS 280 C
Cutting Attachment
Recommended cutting attachments
for compliance with § 5.11 of ANSI
standard B 175.1-2000
(see page 14 of this manual):
STIHL reduced kickback bar
(with green label) for .325" pitch:
Rollomatic with sprocket nose
16, 18 or 20" (40, 45 or 50 cm)
STIHL low kickback chain
1)
(with green label) for 0.325" pitch
Rapid-Micro 2 (23 RM2, 26 RM2)
Rapid-Micro C3 (23 RMC3, 26 RMC3)
for 3/8“ pitch
Rapid-Micro 2 (33 RM2, 36 RM2)
Rapid-Super C3 (33 RSC3, 36 RSC3)
Chain sprocket:
7-tooth for .325" pitch
7-tooth for 3/8“ pitch
1) See definition of "low kickback
chain" on page 17.
In order to comply with the kickback
performance requirements of § 5.11 of
ANSI standard B 175.1-2000, do not use
replacement saw chain unless it has
been designated as meeting the ANSI
§ 5.11 requirements on this specific
powerhead, or has been designated as
"low kickback" saw chain
1) in
accordance with the ANSI B 175.1-2000
standard.
Since new bar/chain combinations may
be developed after publication of this
manual, ask your STIHL dealer for the
latest recommendations.
Other bars and chains available for this
powerhead are:
STIHL yellow-labeled guide bars:
For .325" and 3/8“ pitch:
Rollomatic “S“ with sprocket nose
16, 18 or 20" (40, 45 or 50 cm )
Duromatic with stellite tipped nose
16, 18 or 20" (40, 45 or 50 cm)
STIHL yellow-labeled chains:
for .325" pitch:
Rapid Micro (23/26 RM, 23/26 RMC)
Rapid Super (23/26 RS)
for 3/8“ pitch:
Rapid Micro (33/36 RM),
Rapid Super (33/36 RSC, 33/36 RSK
1) See definition of "low kickback
chain" on page 17.
Contact your STIHL dealer for
information regarding special
accessories that may be available for
your product.
Special Accessories