Smooth Fitness 835 - Manual (Page 15)

www.smoothfitness.com 15
ASSEMBLY – PLEASE READ ALL STEPS BEFORE BEGINNING YOUR WORK.
STEP 1: Assemble the Upright
NOTE: Make sure all wires are recessed into the frame. DO NOT trap or
pinch. DO NOT tighten bolts until STEP 2 .
When attaching the Right upright (310) first attach the 8 pin data cable to the wire
in the upright. This will allow you to pull the data cable up through the upright after
installation.
(1) Slide the base frame covers over uprights.
(2) Attach the Left Upright (wrapped in clear plastic) and Right Upright (wrapped in
green shaded plastic) to the treadmill main frame, and secure using the
M8x15mm Allen Head Bolts (306) with M8 Flat Washers (304). HAND TIGHTEN
ONLY. Do not tighten the M8x15mm Allen Head Bolt (306) until STEP2 has
been completed.
306 X10
304 X10
Bolts should be hand tight only
Green plastic wrap
Clear plastic wrap