Sharp AQUOS 10P03-MX-NM - Manual (Page 43)

41
Presetting Remote Control Function
You can operate the connected AV products (AV
receiver, cable box, SAT tuner, DTV, VCR, DVD, BD,
LD) using the presetting manufacturer function of your
remote control unit.
14
12
11
6
13
10
8
9
7
5
4
3
2
1
Presetting manufacturer codes
1 Press an appropriate button (
STB, DVD
•
VCR or
AUDIO) to operate the connected equipment.
2 Press an appropriate button (
STB, DVD
•
VCR or
AUDIO) and DISPLAY at the same time to enter
the code registration mode.
3 Press 0–9 to enter the manufacturer code. (See
page 42.)
• Preset mode is fi nished once the LED no longer lights
up.
4 After registering the code, the LED will stop blinking
then turn off after one second. (If you perform an
incorrect operation, the LED will blink quickly then
turn off.)
Operating the Connected Equipment
To operate the connected equipment, press STB,
DVD∙VCR or AUDIO to select your device. (STB (cable
converter), DVD, BD, VCR or AUDIO.) The remote
control unit button will function as follows.
• When you operate VCR, DVD or BD, press INPUT to select
the terminal connected to your device.
• CABLE and SAT cannot be selected at the same time.
1 POWER (SOURCE)
• Turns the connected equipment power on and off.
2 I
• Starts playback. (VCR, DVD, BD)
3 G
• Rewinds the tape and allows picture search. (VCR)
• Hold down to go in reverse. (DVD, BD)
4 H
• Stops the tape transport. (VCR)
• Playback stops when pressed. With some DVD/Blu-ray
disc players, pressing the button twice may open the disc
tray. (DVD, BD)
5 K
• Pressing quickly once takes you to the start of the chapter
currently playing. Each time you press it, you move back
to the start of the previous chapter. (DVD, BD)
6 0–9, • (DOT) (STB)
• Press a button (or buttons) that corresponds to the
channel that you wish to watch.
7 J
• Rapidly advances the tape and allows picture search.
(VCR)
• Hold down to fast forward. (DVD, BD)
8 F
• Sets pauses and still pictures. (VCR, DVD, BD)
9 L
• Pressing quickly once takes you to the start of the next
chapter. Each time you press it, you move ahead to the
start of the next chapter. (DVD, BD)
10 E REC
• Starts recording. (VCR)
11 FLASHBACK
• Press to switch between the current channel and the
channel you were watching immediately before. Some
manufacturers do not preset FLASHBACK. (STB)
12 CHr/s
• Press CH r or CH s to tune in to a higher or lower
channel. (STB)
• Press to select the channel of the TV tuner on the VCR.
(VCR)
13 MENU
• When this button is pressed, the DVD/BD menu will
display. (DVD, BD)
14 a/b/c/d, ENTER
• a/b/c/d: Press the button to select items on the STB
GUIDE screen or STB MENU screen. (STB)
Press the button to select items on the DVD/BD menu
screen. (DVD, BD)
• ENTER: Press to activate the selected function. (STB,
DVD, BD)
Other Viewing Options