Sub-Zero IM15/S - Manual (Page 12)

12
W O L F M U LT I - F U N C T I O N C O O K TO P U S E & C A R E
S I G N A T U R E
P O L I S H
Signature Polish
is available from
Signature Limited
Laboratory,
P. O. Box 13436,
Dayton, Ohio
45413-0436, or
call 877-376-5474
(toll free).
C A R E R E C O M M E N D A T I O N S
C O M P O N E N T C A R E R E C O M M E N D A T I O N
Exterior Surface
Stainless steel
Burner Pan
Stainless steel
Although stainless steel is resistant to most stains, it is not totally
impervious to damage. Salt and some cooking liquids may pit and stain the
surface. Always remove these spills immediately.
For the classic stainless steel exterior finish, use a soft, nonabrasive
stainless steel cleaner like Signature Polish (see side note) and apply with a
soft, lint-free cloth. To bring out the natural luster, lightly wipe the surface
with a water-dampened microfiber cloth, followed with a dry microfiber
cloth. All work should follow the grain direction of the finish. Best results are
obtained by keeping the cloth in continuous contact with the metal.
Hard water stains: Use white vinegar and water.
Do not use abrasive cleaners (e.g., Scotch-Brite or Soft Scrub); they will
permanently scratch the surface. Do not use steel wool pads.
Cool first. Wash in warm water and liquid detergent or mild abrasive
cleaners.
Remove from cooktop and place on a flat surface near the sink.
Nonabrasive cleaners: Hot water and liquid detergent, paste of baking soda
and water, plastic pad or sponge.
Mild abrasive and abrasive cleaners: Use sparingly.
To remove the knob, slip an edge of a dish towel under the knob; pull the
edge together. Using the towel for leverage, lift up; the knob pulls off the
valve stem.
General care: Wipe the knob with a damp cloth and mild soap and water;
rinse and dry. Never soak or use abrasive cleaners; they will scratch the
finish and remove the markings.
Spray cleaners: Use to remove fingerprints and greasy food soils. Spray first
on a cloth before wiping panel.
Keep dry; never spray water or cleaner directly on the igniter. When cleaning
around the surface burner, be careful that the cloth does not catch on the
igniter and damage it.
Burner Base
and Head
High-temperature
painted brass
Burner Grate
Porcelain-coated
cast iron
Control Knob
Chrome-plated
Control Panel
Tempered glass
Spark Igniter
Ceramic