Star Micronics Line Thermal/Dot Printer - Manual (Page 68)

Rev. 0.00
3-56
STAR LIne Mode Command Specifications
ESC FS p n m
[Name] Print logo
[Code]
ASCII ESC FS p n m
Hexadecimal 1B 1C 70 n m
Decimal 27 28 112 n m
[Defined Area] Thermal : 1 ≤ n ≤ 255
0 ≤ m ≤ 3, 48 ≤ m ≤ 51, (“0” ≤ m ≤ “3”)
Slip : 1 ≤ n ≤ 255
0 ≤ m ≤ 3, 48 ≤ m ≤ 51, (“0” ≤ m ≤ “3”)
Validation : 1 ≤ n ≤ 255
0 ≤ m ≤ 3, 48 ≤ m ≤ 51, (“0” ≤ m ≤ “3”)
[Initial Value] Thermal : -
Slip : -
Validation : -
[Function] Prints the logo of registration number n registered using the logo registration command ESC FS q
according to the print mode m.
n: Logo Specification
n Function
1 to 255 Specified logo number
m: Print Mode
m Logo Print Mode
0, 48 Normal mode
1, 49 Horizontal double size mode
2, 50 Vertical double size mode
3, 51 Double high/wide mode
• If the parameter is within the defined region, execute this command after printing the unprinted data
in the line buffer.
(Unprinted data is printed regardless of whether the specified logo was registered by n.) )
• It is not possible to print with other data in the same line (characters, bit images, bar codes).
• Form feed obeys the vertical print size of the logo.
• Print modes, excluding upside-down printing (enhanced, double, underline, character size, black/
white inverted, and 90˚ right rotation) are unaffected.
• If the logo horizontal print size exceeds the horizontal print region, the portion exceeding the area is
not printed.
• When page mode is selected, supports only vertical double high, and horizontal double wide
modes.
• Logos are printed according to the following command settings.
• Left margin (ESC I n)
• Right margin (ESC Q n)
• Position alignment (ESC GS a n)
• Absolute position movement (ESC GS A n1 n2)
• Relative position movement (ESC GS R n1 n2)
• Horizontal tab (HT)
• Upside-down printing (SI)