Schlage LINK WCW100 - Manual

Camera User Guide
There are two cameras available for use with the Schlage
LiNK system.
WCW100
The WCW100 is a wireless camera that communicates
with the Schlage LiNK system through your existing
wireless router.
WCE100
The WCE100 is a wired camera that communicates with
the Schlage LiNK system through your existing router.
PO WER
NETW OR K
WCW100 Wireless Camera
PO WER
NETW OR K
WCE100 Wired Camera
DO NOT connect Ethernet or power before
enrolling the camera.
For indoor use ONLY!
!
Plastic
Nut
Plastic
Washer
Threaded
Post
Attaching the Camera to the Stand
Attaching the Antenna
Wireless Antenna (WCW100 Only)
Rotate the wireless antenna onto the threaded post to ensure clear wireless
communication. Antenna can be adjusted to obtain a better signal. Best results
are usually obtained by positioning the antenna vertically.
Camera Stand
Install the camera stand to provide a steady base for the camera.
1. Loosen the plastic nut on the back of the camera.
2. Rotate the threaded post upwards.
3. Rotate the camera onto the threaded post until it stops.
4. Tighten plastic washer against camera to secure.