Schlage LINK WCW100 - Manual (Page 2)

Privacy Button
The privacy button can be used to temporarily suspend video transmission.
Enable Privacy
Press the privacy button. Button will light green when activated.
Disable Privacy
Press the privacy button. Green light will go out when video transmission
resumes.
PO WER
NE TW OR K
Privacy
Button
Privacy Button
Reset Button
Î Using the reset button is not recommended.
To change camera setup, follow the steps under Moving the Camera to a
Different Account.
Î Pressing the reset button will restore factory default camera settings.
In most cases, this WILL NOT correct issues with connecting or
viewing the camera.
1. Connect power to camera.
2. Using a small pin, press and hold the reset button for 15 seconds. Then
release the button.
3. LEDs will turn off and then on.
NETW ORK
POWER
Do Not
Use
Reset Button
Power, Ethernet and MAC ID
DO NOT connect power and Ethernet until instructed to do so by the web
site, during the enrollment process.
MAC ID is located on the label on the back of the camera.
WPS
POWER
LAN
Speaker OUT
5V/1A
IC ID: 7954A
WCW100
XXXXXXXXXX
XXXXXXXXXX
Power and Ethernet
WPS Button
DO NOT use the WPS button. Pushing this button may prevent the camera from
enrolling to the LiNK system properly.
If the button is accidentally pushed, power must be disconnected and then
reconnected to the camera before enrolling the camera.
Do Not
Use
IC ID: 7954A
WCW100
XXXXXXXXXX
XXXXXXXXXX
WPS
POWER
LAN
Speaker
OUT
5V/1A
WPS Button