Sherwood HSB-600 - Manual (Page 12)

4. RS-232C
• This port may be used to update the operating software, etc. for improvement in the future.
5. AC INPUT CORD
• Plug this cord into a wall AC outlet.
• The multi-room system kit(sold separately) is essential for operation from a remote location.
For information on the multi-room system kit, contact the Xantech corporation at 1-800-843-5465 or
www.xantech.com.
• IR IN jack allows you to control this receiver from another room with the remote control unit.
• To control this unit from another room with the remote control unit, connect the IR IN jack to the output of
the connecting block.
• If this unit is located inside a cabinet or other enclosure where the infrared beams from the remote control
unit cannot enter, then operation with the remote control unit will not be possible.
In such a case, connect the IR IN jack to the output of the connecting block.
Note:
• Remote operation may become unreliable if the IR receiver is exposed to strong light such as direct sunlight or
inverted fluorescent.
11
3. CONNECTING MULTI-ROOM SYSTEM KIT