Sherwood HSB-600 - Manual (Page 13)

Operations
Select the desired input source.
2
• Each time the POWER(ON/STANDBY) button on
the front panel is pressed, this unit is turned on to
enter the operating mode (the STANDBY indicator
lights up in bule) or off to enter the standby mode
(the STANDBY indicator lights up in red).
• On the remote control, press the POWER ON
button to enter the operating mode or press the
STANDBY button to enter the standby mode.
• In the standby mode, the STANDBY indicator
lights up in red. This means that the unit is not
disconnected from the AC mains and a small
amount of current is retained to support the
operation readiness.
• Each time the "INPUT" button on the front panel
is pressed, the input source changes as follows;
HDMI 1 HDMI 2 AV
• Each time the input source is changed, the
corresponding indicator lights up.
Turn the power on.
1
12