Stamina Products Magnetic Upright Exercise Bike 15-5325 - Manual (Page 16)

STORAGE
1.
2.
3.
4.
To store the Magnetic Upright 5325 Bike, simply keep it in a clean dry place.
The Magnetic Upright 5325 Bike is approximately 38 1/2 inches long x 22 inches wide x 52 inches tall.
These dimensions may vary. Please measure your Magnetic Upright 5325 Bike if exact dimensions are
needed.
Move the Magnetic Upright 5325 Bike with the moving wheels on the FRONT STABILIZER(2). Grasp
on the HANDLEBAR(5), tip the Magnetic Upright 5325 Bike forward and move slowly.
To avoid damage to the electronics, remove the batteries before storing the Magnetic Upright 5325
Bike for one year or more.
MAINTENANCE
16
The safety and integrity designed into the Magnetic Upright 5325 Bike can only be maintained when the
Magnetic Upright 5325 Bike is regularly examined for damage and wear. Special attention should be given
to the following:
Adjust the TENSION KNOB(25) and verify that the Magnetic System provides tension. The Magnetic
System should provide many years of use.
Use a wrench to verify that the pedals are tightened securely. If tightening is required, remember that the
left pedal has left hand threads and is tightened by turning counterclockwise.
Verify that the WARNING LABEL(70) is in place and easy to read. Call Stamina Products immediately at
1-800-375-7520 for a replacement WARNING LABEL(70) if it is missing or damaged.
Do not step on any portion of the plastic cover when getting on or off the Bike. This can cause the plastic
cover to crack.
It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
Worn or damaged components shall be replaced immediately or the Magnetic Upright 5325 Bike removed
from service until repair is made.
Only Stamina Products supplied components shall be used to maintain/repair the Magnetic Upright
5325 Bike.
Keep your Magnetic Upright 5325 Bike clean by wiping with an absorbent cloth after use. 1.
2.
3.
4.
5.
6.
7.
8.
COMPUTER INSTRUCTIONS
HOW TO INSTALL AND REPLACE BATTERY:
AA Batteries
1.
2.
Do not mix a new battery with an old battery.
Use the same type of battery. Do not mix an alkaline battery with
another type of battery.
Rechargeable batteries are not recommended. 1.
2.
3.
NOTE:
Open the Battery Door on the back of the computer.
The computer operates with two AA batteries. Two batteries are
included. Refer to the illustration to install or replace the batteries.
OPERATION DESCRIPTIONS
To stop a running program, stop pedaling for 4 seconds to switch into STOP mode. In this mode, you can
move the pedals again to continue to run the current program, or you can press the SET button to select
a new program. The function values of DISTANCE and CALORIES will continue to accumulate.
When you complete a program, you can stop pedaling and press SET button to select a new program.
The function values of DISTANCE and CALORIES will continue to accumulate. This will allow you to run
several programs and still know the total DISTANCE and CALORIES during the workout.
If you want to restart with a new program, press and hold the MODE button down for two seconds to reset
all of the function values to zero. Press SET button to select a new program.
The computer will shut off automatically after 3 minutes of inactivity, and the function values, DISTANCE
and CALORIES, will be kept. 1.
2.
3.
4.