Sony PEGA-CC5 - Manual (Page 75)

75
Additional information
This section describes how to solve common problems you may encounter when using
your CLIÉ™ handheld with the car cradle.
Maintenance
Fuse replacement
If the car cradle does not function correctly when connected to the car battery
adapter, make sure that the fuse in the car battery adapter has not burned out.
If it has burned out, replace the fuse by the following procedures.
1
Pull the car battery adapter out of the cigarette lighter
socket.
2
Detach the end of the plug by turning it
counterclockwise.
3
Replace the fuse with a new (identical rating) one.
4
Reattach the end of the plug by firmly turning it
clockwise.
Notes
• When replacing the fuse, use one of the correct amperage, as stated on the fuse
case. (2.5 A, 125 V DC, approx. 30 mm)
• Do not replace the fuse with a wire.
• If the replaced fuse immediately burns out again, consult your car dealer.
Fuse
Cigarette lighter plug
End of
the plug
to remove
to tighten
Continued on next page
• • • • • • • • • • • • • • • • • • • • • • • • • • •