Sony DAR-RH7000 - Manual (Page 21)

21
H
ook
up
s and
Se
tti
n
gs
4
Hang the speakers on the screws.
Notes
• Use screws that are suitable for the wall material and
strength. In the case of a plaster board wall, attach the
screws securely to a beam and fasten them to the wall.
• Install the speakers on a vertical, flat wall where
reinforcement is applied.
• Contact a screw shop or installer regarding the wall
material or screws to be used.
• Sony is not responsible for accident or damage caused
by improper installation, insufficient wall strength or
improper screw installation, natural calamity, etc.
Step 3: Connecting the FM/
AM Aerials
z Hints
• AM loop aerial’s cord (A) and (B) can be connected to
either terminal.
• If FM reception is poor, use a 75-ohm coaxial cable
(not supplied) to connect the system to an outdoor FM
aerial as shown below.
Notes
• To prevent noise pickup, keep the AM loop aerial away
from the system and other equipment.
• Be sure to fully extend the FM wire aerial.
• Keep the FM wire aerial as horizontal as possible.
4.6 mm
10 mm
AERIAL
AM FM75
COAXIAL
AM loop aerial
(supplied)
Subwoofer
FM wire aerial (supplied)
A
B
AERIAL
AM
FM75
COAXIAL
Outdoor FM aerial
(not supplied)
Subwoofer