Sanyo VCC-WB4000P - Manual (Page 67)

PPP Settings
3
Set the following items.
A LOGIN ID:
Type in a username of 48 characters or
less to use for the dial-up networking
settings on the computer.
B PASSWORD:
Type in a password of 19 characters or
less to use for the dial-up networking
settings on the computer.
C IP ADDRESS:
Type in the IP address for the camera to
use during the PPP connection.
•
Default address: 192.168.250.250
Note: The same IP address that is used
for camera network settings can be
typed in, but in such cases, it will
not be possible to connect using
the wired LAN while a PPP
connection is in progress. To use
both connections simultaneously,
type in different subnets.
Do not set the IP ADDRESS and
the CLIENT IP ADDRESS to the
same address.
D CLIENT IP ADDRESS:
Type in the IP address that is assigned to
the computer during the PPP connection.
•
Default address: 192.168.250.251
This IP address is set automatically by
the computer.
Note: If the computer is being used in an
intra-company LAN, set a subnet
that is different from the setting for
the LAN.
4
Select the authentication settings
(AUTHENTICATION).
This sets the authentication protocol to be
used when connecting to the access point. It
should normally be set to “AUTO”.
Available settings:
•
AUTO (default setting): PAP or CHAP is
chosen automatically as required.
•
PAP: Only PAP authentication is used.
•
CHAP: Only CHAP authentication is used.
5
Click the [SET] button.
The PPP SET screen will be displayed.
6
Make the settings in the PPP setting
screen
The settings method for CIRCUIT TYPE, AT
command input, BAUD RATE, DATA SIZE,
PARITY and STOP BIT are the same as
those given in steps
7 to 9 in “ A PPP
Connection to an Internet Service
Provider”.
Note:
•
The IP address and the client IP address
contain the default addresses that are set at
the time of shipment from the factory. If there
is no problem with using these addresses,
then they can be used as they are. Observe
the notes given here if you change either of
the addresses.
•
The dial-up networking settings should also
be made separately for the computer.
•
When you have finished using the connection
from the computer, the telephone line will not
be disconnected when the browser is closed,
so you will need to use dial-up networking to
actually terminate the connection.
4
A
B
C
D
L5AM2/XE (VCC-WB4000P) GB 2004, 2, 17
– 66 – English