Sanus Systems WFV44 - Manual (Page 5)

Step 6: Add Side Panel
Press fit the Side Panel (v) against the Stretchers (o,p) so the Cam Pin (a) goes into the hole which the Cams (b) point to. The Dowel (d)
going into the adjacent hole. Tighten each Cam in a clockwise motion until the Stretchers are secured to the Side Panel. See Diagram 6
for assistance. Note: Make sure the hinge holes on the Side Panel are on the same side as the Front Stretchers.
Detailed View
Diagram 6
a
hinge
holes
o
v
Step 7: Add Shelf Pins and Bottom Shelf
Thread the Shelf Pins (e) into the bottom hole in the line of holes in each Panel (u,v,w). Tighten Shelf Pins with a Phillips screw driver.
Add the Bottom Shelf (q) by inserting it into the assembly and press fit it onto the Shelf Pins. Make sure the Bottom Shelf is flush
against the Front Stretcher (o). If there is a gap in front, shelf may be backward. See Diagram 7 for assistance. Note: Diagram 7 is a
Back View.
Detailed View
Diagram 7
w
u
e
q
v