Sony PCWA-C500 - Manual (Page 39)

39
Wireless LAN connection
6
Click Connect.
Communication with the Access Point is established.
If you are not going to change the Access Point settings, this completes
all the necessary settings. If you want to change the Access Point
settings, follow the instructions below.
Note
To use Access Point to connect to the Internet, you must change the Access Point
factory default settings.
7
Click AP Setting on the Wireless Panel.
Your web browser starts and displays the Access Point setup page.
Notes
• If your web browser is configured to use a web proxy server, set the web browser
proxy setting so that the browser does not use a proxy server for the Access Point
IP address. (The factory default Access Point IP address is 192.168.11.1.)
• Depending on the firmware version of the Access Point, the Access Point setup
page may differ from the following screen.