Sony CMT-BX7DAB - Manual (Page 12)

CMT-BX7DAB.GB.3-095-508-11(1)
1 GB
To run the DAB Automatic Scan
When you turn on the system for the first
time after you purchase the system, DAB
Automatic Scan starts automatically and
creates a list of available services. If you
want to run the DAB Automatic Scan
again, perform the procedure below.
1
Press DAB AUTO SCAN  on the
unit.
“AUTO SCAN” and “PUSH ENTR”
appear.
2
Press ENTER  .
Scanning begins. The scanning
progress is indicated by advancing
asterisks. Depending on the DAB
services available in your area,
scanning may take a few minutes.
When scanning is complete, a list of
available services is created.
Notes
 If your country or region does not support
DAB broadcast, “NO SERV” appears.
 Do not press any button on the unit or
the remote during DAB Automatic Scan.
Scanning is interrupted and service list may
not be created properly. In this case, run the
DAB Automatic Scan again.
 If you move to another area, repeat this
procedure to store the stations for your new
area.
 This procedure clears all previously stored
presets.
 Before unplugging the DAB antenna, make
sure the system is turned off to preserve your
own DAB settings.
 This tuner does not support data services.
Setting the clock
Use buttons on the remote to set the
clock.
1
Press /  to turn on the
system.
2
Press CLOCK/TIMER SET  .
If the current mode appears on
the display, press /

repeatedly to select “CLOCK SET”
and then press ENTER  .
3
Press /  repeatedly
to set the hour, and then press
ENTER
 .
4
Use the same procedure to set
the minutes.
The clock settings are lost when you
disconnect the power cord or if a
power failure occurs.
To display the clock when the system
is off
Press DISPLAY  . The clock is displayed
for about 8 seconds.