Sony CMT-BX7DAB - Manual (Page 24)

CMT-BX7DAB.GB.3-095-508-11(1)
 GB
Play does not start from the first
track.
 Set the play mode to Normal Play
mode.
Files cannot be played back.
 USB storage media formatted with file
systems other than FAT16 or FAT32
are unsupported.*
 If you use partitioned USB storage
media, only files on the first partition
can be played.
 Files that are encrypted or protected by
passwords, etc. cannot be played back.
* This system supports FAT16 and FAT32, but
some USB storage media may not support all
of these FAT. For details, see the operation
manual of each USB storage media or
contact the manufacturer.
Tuner
Severe hum or noise, or stations
cannot be received. (“TUNED” or “ST”
flashes on the display.)
 Connect the antenna properly.
 Find a location and an orientation that
provide good reception, and then set
up the antenna again.
 Keep the antennas away from the
speaker cords, the power cord and the
USB cable to avoid picking up noise.
 Connect a commercially available
external antenna.
 Consult your nearest Sony dealer if the
supplied AM antenna has come off the
plastic stand.
 Turn off nearby electrical equipment.
“TUNED” does not appear in the
display (DAB only).
 Check all antenna connections, then
perform the DAB Automatic Scan
procedure (see page 12).
 The current DAB service may not be
available. Press +/ (or TUNE +/
on the unit)  to select a different
service.
 If you have moved to another area,
some services/frequencies may have
changed and you may not be able
to tune into your usual broadcast.
Perform the DAB Automatic Scan
procedure to re-register the contents of
broadcasts. (Performing this procedure
clears all previously stored presets.)
To improve tuner reception
Turn off CD player power by using the
CD power management function. By
default, CD power is turned on.
1
Press FUNCTION  repeatedly to
select the CD function, and then turn
off the system.
2
After “STANDBY” stops flashing, press
/  on the unit while holding
down /CANCEL  on the unit.
“CD POWER OFF” appears. With CD
player power turned off, disc access
time is increased. To turn on CD
player power, repeat the procedure
until “CD POWER ON” appears.
To reset the system to factory settings
If the system still does not operate
properly, reset the system to factory
settings.
Use buttons on the unit to reset the
system to its factory default settings.
1
Disconnect and reconnect the power
cord, and then turn on the system.
2
Press   , /CANCEL  and
/  at the same time.
All user-configured settings, such as
preset radio stations, timer, and the
clock, are deleted.