Salton, Inc MEK1 - Manual (Page 5)

5
Before Using Your
Express Kettle
Thoroughly clean your Kettle before using. Fill the Kettle to its
maximum capacity (1 or 1.5 litres depending on model) with water
and boil. See boiling instructions. When the unit shuts off, discard
the water. Rinse the Kettle out with cold water. Wait ten minutes to
allow the heating element to cool. Repeat this process two more
times.
Boiling Instructions
1. Remove Kettle from the Power Base.
2. Place Power Base on a level counter. The Power Base must
be dry before use.
Figure 1
a. Lid Release
b. Indicator Light
c. ON/OFF
“START” Lever
d. Power Base
MEK1
(P/N 30774)
MEK15
(P/N 31013)
e. Scale Filter
(P/N 30775))
b.
e.
c.
d.
a.
Your new Electric Kettle is designed to heat water only. Do not put
any food or beverage into the kettle.