Salton, Inc MEK1 - Manual (Page 6)

6
3. Raise the ON/OFF Lever into the OFF position.
4. Open the Lid by pulling back on the Lid Release. Fill the Kettle
with the desired amount of water. Close the Lid and wipe
excess water off the Kettle.
NOTE: If the Lid is not properly closed, the Kettle will not auto-
matically shut off.
5. Place the Kettle on the Power Base, engaging the connector
into the bottom of the Kettle. Be careful not to spill any water
onto the Power Base.
6. Plug the Power Base into 120V ~ 60 Hz electrical outlet.
7. Press the ON/OFF Lever into the ON position, the Indicator
Light will come on.
8. When the water comes to a boil the Kettle will automatically
shut off and the Indicator Light will turn off.
NOTE: The Kettle can be turned off at any time during the
heating process by using the ON/OFF Lever.
9. Remove the Kettle from the Power Base before pouring.
NOTE: Always wait until the Kettle is off before removing it
from the Power Base.
10. To reheat water, place Kettle back onto Power Base and press
ON/OFF Lever into the ON position. Be careful not to spill any
water onto the Power Base.
11. Unplug the Power Base when not in use. Allow it to cool before
reuse.
Cleaning Your
Express Kettle
CAUTION: Do not immerse Kettle or Power Base in any liquid,
or place in a dishwasher to be cleaned.
1. Turn off and unplug unit. Allow it to cool before cleaning.
2. Remove the Scale Filter from inside the Kettle by pulling
straight up and out of bracket. Rinse under running water and
use a soft brush if necessary (no metal brush). Replace Scale
Filter.
3. Rinse the inside of the Kettle with water, and wipe it with a
damp cloth.
NOTE: Do not use highly corrosive or abrasive cleaning
agents or brushes.
4. Wipe the Power Base unit with a damp cloth.