Editi ng a r ecor d ed m inidisc – Sharp TINSE0568AWZZ User Manual
Page 62
62
IM-DR580H
03/10/15 IM-DR580H(E)7.fm
IM-DR580H(E) TINSE0568AWZZ
Editi
ng
a R
ecor
d
ed M
iniDisc
-T
it
li
n
g
a
M
in
iD
is
c
-
Titling a MiniDisc (continued)
Master MiniDisc operation
[Operate with the remote control]
For stamping, leave the main unit off the multi-link station
as you need to eject and load MiniDiscs. Use the remote
control for the operation.
Operation of the MiniDisc for stamping
Note:
If this happens, adjust the total number of tracks on the
newly recorded MiniDisc using the edit operation.
1
Insert a master MiniDisc.
Do not mistake the master MiniDisc for the target one.
2
Whilst in the stop mode, press the MENU button.
The unit enters the menu select mode.
3
Select "EDIT" by pressing the
or
button and press the
button.
4
Select "N-STAMP" by press-
ing the
or
button and
press the
button.
5
Press the
button.
6
When the unit displays
"CHANGE MD", remove the
master MiniDisc.
Remove it without turning off the power. Or, the oper-
ation will be cancelled.
7
Load a MiniDisc for stamping.
8
Press the
button.
The unit will finish recording the
character information and enter
the stop mode.
If the total number of tracks on the
master MiniDisc does not match
that on the MiniDisc for stamping,
"Can't E" appears and the unit
turns off.