SVAT Electronics CV0104DVR - Manual (Page 7)

CV0104DVR 4
SVAT ELECTRONICS
Now You Can See
2. INST 2. INST ALLA ALLA TION TION
CONNECTORS ON THE REAR PANEL
Please setup the connection by following the illustration shown below (detailed
instructions on using the network function can be found in Section 9):
1) Plug the power cord into your DVR and plug it into an outlet. SVAT recommends
plugging it into a surge protected power bar for your device's protection.
2) Plug the BNC Connectors into each video input you plan on using. For
example, if you are using 3 cameras with this system, then plug BNC convertors into
inputs 1-3. Plug BNC convertor into the video output as well.
3) Plug your camera(s) into the video input jacks using the 60ft extension wires.
4) Use an RCA wire to connect your television to the video output of the DVR. Make
sure the RCA wire is plugged into the video input of your television. Note: This
system does not support audio, so if you are using an audio/video RCA wire, there
is no need to plug in the red or white inputs. On your television switch to the
video/audio input channel
5) Your system is now installed and ready for use.