Star Trac 6800 - Manual (Page 10)

Page 10 STAR TRAC GROUP CYCLES OWNER’S GUIDE
ASSEMBLY
Following these steps in order will minimize the build time and ensure proper assembly.
Note: Not all of the following procedures are performed on all models; Spinner ® Pro, Elite and NXT. If the procedure is specific to a model it will be
noted as follows: NXT Only, Pro/Elite Only, NXT/Elite Only, or Pro Only.
1. Install the Back Leg
NXT Only
Lift up the rear of the bike frame and place
the rear leg assembly in position under the
frame, aligning the holes in the leg with the
holes in the frame.
Position the leg so the thicker end faces
toward the front of the bike
Using the 5mm hex wrench and a 13mm
combination wrench insert 2- M10X55mm
(rear-most holes) and 2-M10X65mm
(front-most
holes) button head screws, nuts Step 1 (NXT)
and washers (under bolt head and nut), to
secure the rear leg assembly to the frame.
Tighten all hardware securely using a torque wrench to 85 Inch Pounds
Pro & Elite Only
Lift up the rear of the bike frame and place
the rear leg assembly in position under the
frame, aligning the holes in the leg with the
holes in the frame.
Using the 5mm hex wrench and a 13mm
combination wrench insert 2- M10X55mm
flat head screws, nuts and washers to secure
the rear leg assembly to the frame
Tighten all screws/nuts securely using a torque wrench to 85 Inch Pounds
Step 1 (Pro/Elite)
2. Install the Front Leg
NOTE: The front foot assembly has wheels attached to the front edge. Be sure the wheels face forward when installing the front leg assembly.
Stand the bike frame upright and gently tip the front of the bike up and position the front foot under the frame, with the wheels facing forward.
Attach the front foot assembly to the frame, aligning the holes in the foot with the holes in the frame.
NXT Only
Position the leg so the thicker end and wheels face
toward the front of the bike
Using the 5mm hex wrench and a 13mm combination
wrench insert 2- M10X55mm (rear-most holes) and
2-M10X65mm (front-most holes) button head screws,
nuts and washers (under bolt head and nut), to secure
the front leg assembly to the frame.
Tighten all hardware securely using a torque wrench to 85 Inch Pounds
Step 2 (NXT)