Samsung SRS610HDSS - Manual (Page 19)

setting up _1
setting up your side-by-side
refrigerator
Connecting the water line to the refrigerator
1. Remove the cap from water line on the unit and insert compression nut to the water line on
the unit after disassembling from provided water line.
2. Connect both water line from the unit and water line provided kit.
3. Tighten the compression nut onto the compression fitting. Be careful no gap between two items.
4. Turn water on and check for any leakage.
Only connect the water line to a drinkable water source.
If you have to repair or disassemble the water line, cut off 6.5mm of the plastic tubing to
make sure you get a snug, leak-free connection.
Before being used, the leakage in these places should be examined
• Samsung Warranty does
not cover WATER LINE
INSTALLATION.
• It’ll be done at customer’s
charge except the retail price
includes installation cost.
• Please contact Plumber or
Authorized Installer for the installation if needed.
• If Water leakage happened due to improper installation, Please contact installer.
Installing the water filter.
1. Remove the water filter from the box and put
a replacement indicator sticker on the filter as
shown.
. Place a sticker on the filter that dates six months
in the future. For example, if you install the water
filter in March, put the “SEP” sticker on the filter
to remind you to replace in September. That
way you’ll know when it is time to replace the
filter. Normally filter life is about 6 months.
. Next, remove the fixed cap by turning it counter
clockwise. Keep the cap in a safe place for use
if you choose not to use a filter.
sticker
(Month indication)


1
Remove
cap
Water line
from unit
Water line
from Kit
No gap
loosen a
CAUTION
01
setting
u
P
DA99-01507A(HM-134a)-EN(0.0).ind19 19 2007.4.21 9:59:57 AM